muon-track#

Cherenkov light of one muon-like track, as a sky-frame photon stream filtered to a telescope sphere at the origin. Replaces the earlier fake-muon program; options keep their names.

$ obdeect sources muon-track -x 70 -h 3000 --theta 0 -o muon-track.pst
$ obdeect sources muon-track -x 70 -N 10 --seed 3 -o muon-track.pst 2> summary.txt
$ obdeect sources muon-track -x 70 --index-profile atm_index.txt | obdeect stream cat --summary -

The output is a photon stream, not an image; .pst is only a naming convention.

Geometry and yield#

  • The track runs from -h above the observation level to the impact point (x, y, 0), direction (-sin theta cos phi, -sin theta sin phi, -cos theta).

  • Photons per metre into 4 pi (Frank-Tamm): 2 pi alpha q^2 sin^2(theta_c) (1/wlmin - 1/wlmax), with cos(theta_c) = 1/(n beta).

  • Emission at a fixed angle theta_c to the track, uniform azimuth, uniform along the segment. Wavelengths follow 1/lambda^2 between wlmin and wlmax, exactly (no tabulated grid).

  • Emission time is -D/(beta c) for a point at distance D along the track from the observation level, so t = 0 is the arrival of the particle there.

  • Only photons that reach the telescope sphere (radius -r, centre at the origin) are generated, on straight rays. Weight = fraction of azimuths that hit (exact); the weight sum is the expected number of photons on the sphere. Photons are single (weight 1 or the arc fraction), not bunches.

  • The default impact point (0, 0) gives a track through the sphere centre. Its Cherenkov ring lies at about h tan(theta_c), about 73 m for 3 km, so most photons come from the lower part of the track (below about 620 m, where the sphere subtends more than theta_c).

Output#

  • Frame sky: positions relative to the observation level, z up, metres. No refraction and no extinction: obdeect propagation applies them on the way to the telescope.

  • One run, --events events, one telescope record (the sphere). refraction_applied = 0 and curvature_applied = 0.

Options#

Option

Default

Note

-r, --radius

15 m

sphere radius

-x, -y

0

impact point

-h

3000 m

start altitude

--theta, --phi

0

degrees

-n, --n1

1.000292

index, or n-1

-A const or --index-profile FILE

constant

see below

-a

2150 m

written to the run record only

-b

5

accepted, no effect

-l, -L

240, 1000 nm

200 to 2000 nm

-q, -m, -p, --beta

-1, 0.105658 GeV, -, 1

-p sets beta from the final mass (order-independent; not with --beta)

--primary

6 (mu-)

sets mass and charge

-N, --events

1

1 to 4294967295

--run

1

run number (run record)

--enable-scatter

off

rejected (needs the density profile)

--rscat, -I

0

rejected

--seed

1

random seed

Refractive index#

The default index is constant (-n). --index-profile FILE (lines altitude_m n_minus_1, from simulation-models) gives an altitude-dependent index. The track is stepped in 10 m steps, with the index taken at each mid-point.